The inkjet printer needs to be debugged in advance before it is used, and the result of debugging will directly interfere with the maximum length of time the inkjet printer is used. Therefore, we must pay attention when debugging the inkjet printer. Strictly implement it in accordance with the operating specifications. The following are the things we should pay attention to when debugging the printer. 1. When moving the inkjet printer, be careful, pick up and put it down gently. After powering on, you can not unplug the plug directly to prevent the nozzle of the inkjet printer from being burned. 2. If the printer uses side spray, after starting the machine every other day, some cleaning solution should be applied to the surface of the nozzle of the printer first, and the ink bag needs to be slowly squeezed until the nozzle flows out Ink, place a piece of white paper in front of the print head, press the strong jet button, and slide the white paper at the same time. If you see white lines in the print, you have to squeeze the ink bag again. The effect of printing becomes better. 3. If you are using the downward printing method, after starting the machine the next day, you should loosen the screws on the handle of the nozzle, and then slide the nozzle to a horizontal position, still placing a piece of white paper, and repeat Perform printing work until the printing effect becomes better, then adjust the print head to the place to be printed, tighten the screw on the print head handle, and stabilize the print head. Never change the position of the print head before loosening the screw of the print head. , Because this may cause the print head to be unable to be fastened, which will result in poor printing performance.