Four details neglected in the use of inkjet printers

Details that are easily overlooked, the installation of the print head. The distance between the print head installation position and the printer should not be higher or less than 1.5m; in addition, we need to confirm that the product will not stop under the print head, because the backlog of the production line may cause leakage/partial leakage; at the same time, avoid the nozzle Vibrate to ensure that the nozzle and support are insulated and not sprayed to the production line. Confirm the position of the nozzle to facilitate repair and maintenance operations; finally, the print head should not be placed and installed too low to prevent rebound. Details that are easily overlooked. Second, damage caused by electrical interference. High-voltage wave peaks can cause damage to parts, which may damage sensitive equipment of electrical interference, cause the failure of the microprocessor circuit board, and affect the normal operation of some chips. In this case, we must pay attention to this possibility and do not wind the wires/conductors around the large Avoid using motors and heaters near current wires. Try to keep the length of the wires as short as possible. At the same time, do not share the printer and the production line with the ground. Try to use the main circuit without inductive interference and connect the ground wire. Three easily overlooked details, on-site guidance. If the power supply is not good, it is best to use a voltage stabilizer to reduce power peaks and power loss. Do not use poor grounding, otherwise it may interfere with the input through the electric eye and synchronizer; do not install the printer near the equipment with large interference, such as cables If you don’t know what kind of equipment is around, such as the spark machine of the production line, you should ask the on-site personnel in time; make sure that the print head, the support and the production line are relatively independent, and that the production line will not generate static electricity near the print head. Four easily overlooked details, wiring and conduit arrangement. Shenzhen Meianco recommends the use of cable ties, try to use the correct length of the wire, to avoid causing the print head to swing, consider the bending radius, avoid vibration and high current lines when routing, to ensure that it will not be impacted by other equipment during work. It is best to isolate the printer with a protective cover.